INN3878C-H804
Off-Line QR Flyback Switcher IC with Integrated USB Type-C and USB-PD Controller, High-Voltage Switch, Synchronous Rectification and FluxLink Feedback
Product Details
InnoSwitch3-PD dramatically simplifies the development and manufacturing of USB-PD power supplies by integrating primary switch and controller, isolated feedback, secondary control and USB-PD controller into a single package.
The architecture incorporates a novel inductive coupling feedback scheme, Fluxlink, to provide a safe, reliable, and low-cost means to communicate accurate direct sensing of the output voltage and current. The primary controller on InnoSwitch3-PD is a quasi-resonant (QR) flyback controller that has the ability to operate in continuous conduction mode (CCM), using both variable frequency and variable current control schemes. The InnoSwitch3-PD secondary controller consists of a transmitter circuit that is magnetically coupled to the primary receiver, an I2C interface to control power supply parameters and telemetry functions, a 4.4 V regulator, SR FET driver, QR mode circuit, oscillator and timing functions, and a host of integrated protection features.
Product Highlights
- USB Type C and PD Controller
- USB Power Delivery 3.0 + PPS provider and QC4 support
- Compliant with USB Type-C Rev. 1.3
- Integrated VCONN FETs with soft start and over-current protection
- Supports electronically marked cables
- Configurable pull-up resistor Rp
- On chip temperature sensor
- Telemetry for power supply status and fault monitoring
- PowiGaN technology – up to 100 W without heat sinks
- Dedicated NTC pin for temperature sense
Highly Integrated, Compact Footprint
- Multi-mode Quasi-Resonant (QR) / DCM / CCM flyback controller, high-voltage switch, secondary-side sensing and synchronous rectifier driver
- Optimized efficiency across line and load range
- Integrated FluxLink, HIPOT-isolated, feedback link
- Instantaneous transient response
- Drives low-cost N-channel FET series load switch
EcoSmart – Energy Efficient
- No-load consumption as low as 14 mW
- Enables power supply designs that easily comply with all global energy efficiency regulations
- Low heat dissipation
Advanced Protection / Safety Features
- Input voltage monitoring with accurate brown-in/brown-out and overvoltage protection
- Output OV/UV fault detection with independently configured responses
- Open SR FET gate detection
- Hysteretic thermal shutdown
- Programmable watchdog timer for system faults
- Integrated high voltage FETs for VBUS short protection on CC1, CC2
Full Safety and Regulatory Compliance
- Reinforced insulation
- Isolation voltage >4000 VAC
- 100% production HIPOT compliance testing
- UL1577 isolation voltage 4000 VAC (max) and TUV (EN62368) safety approved
Green Package
- Halogen free and RoHS compliant
Specifications
| Output Power (Max) - Open Frame, 230V | 30.00 W |
| Output Power (Max) - Enclosed, 230V | 30.00 W |
| Output Power (Max) - Enclosed, Univ | 30.00 W |
| Output Power (Max) - Open Frame, Univ | 30.00 W |
| Switching Frequency (min) | 25.00 kHz |
| Switching Frequency (max) | 95 kHz |
| Breakdown Voltage | 750 V |
| Voltage - Output (Min) | 3.00 V |
| Voltage - Output (Max) | 24.00 V |
| Voltage - Input (Min) | 85 V |
| Voltage - Input (Max) | 265 V |
| Auto-Restart & Overvoltage Response |
Auto-restart
Latch Off
|
| Cable Drop Compensation | X |
| IC Package | InSOP-24D |
| Internal Switch | Yes |
| Over-Temperature Response | Hysteretic |
| PowiGaN? | Yes |
| Temperature - Operating (Min) | -40 °C |
| Temperature - Operating (Max) | 150 °C |
| Control Scheme | Fluxlink |
| Protection Features |
Input Overvoltage
Input Undervoltage
Open SR FET Detection
Output Overload
Output Overvoltage
Output Short Circuit
Overtemperature
|
| Output Profile | CV/CC |
| Topology | Flyback |
| PDOs & APDOs |
5V/3A
9V/3A
12V/2.5A
15V/2A
20V/1.5A
3.3-11V/3A
3.3-16V/2A
|
| Product Sub-Type | PMIC |
| MSL Rating | 3 |
| Secondary Response |
Auto-restart
Latch Off
|
